Give Glory to Galvatron’s Holes!! All Hail Galvatron!

Several of us who received the early waves of Transformers Kingdom Leader Class Galvatron unfortunately found that the shoulders were misassembled at the factory.

The misassembled shoulders cause the arms to sit lower than they should creating problems with the proportions of the figure.
There is a way to pry the arms apart, remove the pin, flip the shoulder piece, then try to put it all back together again (videos of which are available on YouTube). However, those of us who either don’t have the time, the skill, or the courage to attempt this repair, have only been able to rotate the arms around having the back side of the shoulders facing forward.

This makes the proportions of the robot mode a lot better, but moves the unsightly 5 millimeter pin holes to the front of the shoulders.
This is the best most of us could do when displaying our misassembled Galvatron. That is until now!
Gizmoboy with The AllSpark has created 3D printed accessories to fill the holes AND give Galvatron a more regal look fitting of the Emperor of Destruction!

The part consists of an 3D Extruded Decepticon symbol raised off of a 10mm diameter disk which has a 5mm post on the back side.

Once printed, I applied some paint apps in true Decepticon colors.

Once the paint dries, the pieces can be easily inserted into the 5mm pin holes on the shoulders.

These parts are now available on Shapeways at Gizmoboy’s Gizmos!
Get your set today and give your Galvatron the upgrade he deserves!